![]() Click Add, from the drop-down list select VPN Tunnel.Navigate to Network Management > Network Interface.This section represents the configuration of the VPN tunnel interface/routing and assumes basic configuration of LAN/WAN interfaces and a default route is already configured.Ī tunnel interface is created to the peer device. The diagram below represents the topology used in this post. This post describes how to configure a route-based VPN between a Check Point R81.10 gateway and a Cisco IOS-XE router, with the Check Point configuration covered in detail. The routing table determines which traffic is sent through the tunnel based on the destination IP address, routing protocols such as BGP, OSPF, EIGRP (Cisco only) and static routes can be used to route the traffic through the corresponding VPN tunnel interface. There is a pair of IPSec Security Associations (SA) one inbound and one outbound, with a traffic selector (proxy ID) of 0.0.0.0/0.0.0.0. A route-based VPN is an IPSec VPN tunnel created between two endpoints.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |